Push-fit systems: installation features
Push-fit systems: installation guide
SME Range, socket pipes and fittings
Insert the gasket into the socket
Apply a small amount of jointing lubricant
on the pipe or fitting spigot,
rather than on the rubber gasket to ease the fixing.
Push joint into the pipe or fitting socket, ensuring
the central register is abutted against the spigot edge evenly.
Remove any excess lubricant
EEZI-FIT range: spigot pipes and push-fit fittings
The EEZI-FIT range is made of SMU-ENSIGN spigot pipes and EEZI-FIT push fit fittings.
When the pipe has been cut, please remove any sharp edges (chamfering is not necessary), prior to the assembly
Apply a small amount of jointing lubricant on the lip of the
rubber gaskets , both ends to ease insertion of pipe/fittings.
Push joint over the end of pipe, ensuring the central register
is abutted against the spigot edge evenly.
Push the second pipe or fitting into the gasket again
ensuring that the spigot is abutted
against the central register.
Saint-Gobain PAM recommends the use of its own jointing lubricant available in 0.5kg tubs and proven to be perfectly adapted not to damage the EPDM.
Product Code of the lubricant: 199037.
Please read health and safety instructions when using this product.